resources
 
  .


 
MLW800RF
 

The W800RF32 family of RF receivers are designed to receive X10 RF signals generated from X10 products: Palm Pad remotes, key chain remotes, and many, many other X10 RF devices.

The W800RF32 then sends these commands directly to your computer's serial(RS232) port. This allows your computer to receive X10 RF commands from remotes directly, without having to broadcast any power line commands, thus minimizing power line clutter and improving home automation response times by bypassing the usual power line delay.

Now these X10 commands can also send MLServeCmd's when received. Which means anything Cinemar can communicate with X10 can too. Open programs, switch MainLobby scenes, control your Russound CAV, sprinklers, trigger Elk outputs, send IR or serial commands through the Global Cache and much more.
 

MLW800RF Plug-in

Price: US $29.99

 
 
 
  Software Requirements
 
MainLobby 2 or 3
MLServer
MLW800RF Plug-in
   
   
  Hardware Requirements
 
WGL Designs W800RF
   
   
  Features
 
Send an MLServeCmd based on an X10 command
Assign Aliases to each command
Create an X10 combination unlock code to enable the Plug-in
Adjust X10 command incoming sensitivity to prevent duplicate MLServeCmd's
Communicate and control all other Plug-ins
Event Log for Debugging and viewing all incoming traffic
   
   
  Applications/Usage
 
  Use an X10 command to...
Open Programs and Applications
Play back music clip based on X10 motion sensors
Turn on Russound Zones or send UNO Keypad controls from Outdoors *
Trigger Outputs for Alarms on your ElkM1 *
Create a wireless whole house remote control
Change Scenes (place an X10 motion sensor next to your touch screen and have scene go to a Default Home Page)
Turn on/off Sprinkler Zones outside the home * (MLRain8Net Plug-In)
Switch XM Stations in XMLobby *
Control Serial or IR devices using the Global Cache *
   
  * May require additional Plug-In